Mace MAS-WA-SYS Betriebsanweisung Seite 1

User GuideModel: MAS-WA-SYS

10a. adjuStinG exit delayThe default setting of the Wireless Alarm Panel allows the user 20 seconds to exit the property before the alarm is ARMED. H

113Press then (as many times as required) to set the new Entry Delay• When is pressed the first time the panel flashes with the number of second

12e. arminG the SyStemOn the Keychain Remote Control: Press to ARM the system.On the Wireless Alarm Panel: First make sure the panel is in STANDBY

132(1234 or 4-digit PIN) + Enter 4-digit PIN for setting followed by The panel will display the below image:3Press then to set the ARM mode– Toggl

14a. enterinG alert mOde• On the Keychain Remote: Press to activate.• On the Wireless Alarm Panel: First make sure the panel is in STAN DBY mode, a

153.3.4 hOme mOde There are default settings that allow the system to operate after opening the package. These settings can be adjusted to suit your

1624-digit PIN + Enter 4-digit PIN for setting followed by The panel will display the below image:(One beep indicates that you entered a valid PIN, th

17a. POwerinG uP the dOOr/windOw SenSOrS• Remove the battery cover; insert new batteries noting the polarity as shown in the diagram below and repl

18d. walk teStAfter mounting the sensor at the desired location, it is important to perform a walk test in order to determine if the sensor is detect

19Keys Description Note1(1234 or 4-digit PIN) + You must be in STANDBY mode before enrolling a new Remote Control onto the Wireless Alarm Panel*To mak

2CONTENTSSection 1: Getting started ...

20iv. deletinG a remOte cOntrOl frOm the wireleSS alarm PanelIf a Remote Control device is damaged or lost, it can be deleted from the system as foll

213Press then to go into Remote Querying mode, and then press any key on the remote to check its ID.- After entering into Remote Querying mode, th

22SECTION 5: TROUBLESHOOTING5.1 faQSQ1: What is the best way to set up my system? Where should I put my Wireless Alarm Panel and the sensors?A1: W

235.2 trOuBleShOOtinGAC power failure:This may occur if your security system is accidentally unplugged or if there has been a main power cut. If a fu

246.2.4 mOtiOn SenSOrPower source: ... 9V alkaline battery x

3 4.2.1 Installing the Door/Window Sensor A. Powering up the Door/Window Sensor B. Installing the Door/Window Sensor C. Mounting with th

4SECTION 1: GETTING STARTED1.1 General SyStem OverviewCAUTION!The 9V battery in the Wireless Alarm Panel is for power back-up purposes only, and the

51.4 intrOductiOn tO the wireleSS alarm PanelOther:9V DC INPUT port For AC/DC adaptorSiren output 120dBBattery compartment: For 9V Alkaline back-up b

61.5 intrOductiOn tO the Panel SOund alert & BackliGhtOperating Mode Situation Sound Alert and Backlight Indication1ARMZone triggeredunder ARM st

7• Tape the template onto the wall, in the position you wish to install the Wireless Alarm Panel.• Mark on the wall the points for drilling holes fo

82.3 underStandinG the Battery & ac adaPtOr icOnBattery icon shows power status:FULL HIGH MIDDLE LOW Battery icon shows when the AC power supply

93.2 tranSmittinG an emerGency (Panic) alarm3.2.1 uSinG the Panic alarmPressing & buttons together on the Keypad or Keychain Remote Control